Small Metal Display Easel Back for ChromaLuxe Panels



In stock
SKU
SB4060-C

The brushed silver aluminum easels come with pre-applied two-sided adhesive to be used for displaying ChromaLuxe Aluminum Photo Panels on the wall or on a table top.

Note: The small easel works best for panels that are vertical and 5" x 7" or larger.

For installation instructions, click here!

Instructions on using metal easel with ChromaLuxe photo panels:

When using it as an easel:

1. Lay the photo panel face-down on a clean surface.
2. Remove the protective film from the adhesive square on the top section of the easel. 
3. Line up the bottom of the easel at the bottom-center of the photo panel. Once you have properly aligned it, press the top section firmly. 
a. WARNING: Do not press the taped area of the easel down until proper alignment has been finalized. The adhesive is strong and difficult to remove once set. 
4. While holding the panel firmly, bend the bottom section out to a 30-45 degree angle. Your panel is now ready to display.

When using it as a wall hanger:

1. Lay the photo panel face-down on a clean surface. 
2. Bend the top loop of the easel out at approximately a 45 degree angle. 
3. Remove the protective film from the adhesive square on the top section of the easel. 
4. Visually align the easel to be near the top or centered (or as close to it as possible). Once you have properly aligned it, press the top section firmly.
a. WARNING: Do not press the taped area of the easel down until proper alignment has been finalized. The adhesive is strong and difficult to remove once set. 
5. While holding the panel firmly, bend the bottom section out to a 15-20 degree angle. Your panel is now ready to display.

More Information
Manufacturer Coastal
Color No
Print Applications Dye-Sublimation
Substrate Material Metal
Item Height No
Item Width No
Thickness No
Finish No
See Full Instructions/Documentation Click here