White Ceramic Sublimation Beer Stein with Gold Trim - 22oz.

SKU
22338G

Our ceramic beer steins look just like the drinkware at your favorite pub! The traditional decorative elements and gold band on the top and bottom make this product a must have for any restaurant or bar! This stein is fully sublimatable and the white exterior surface only emphasizes the colors in your image.

Specifications:

  • White ceramic beer stein with gold trim on top and bottom
  • Capacity: 22oz.
  • For use with a Mug Press or Stein Wrap
Our Sublimation Heating Pad is STRONGLY RECOMMENDED when using a mug press!

Helpful Resources

Note: Our Sublimation Heating Pad is STRONGLY RECOMMENDED when using a mug press!

Mug Master Pro Mug Press

Idle Temperature: 300°F
Press Temperature: 360°F
Time: 280 Seconds
Pressure: Medium

  • Tape the sublimation paper with image printed in reverse to the stein with thermal tape
  • When the heat press reaches the idle temperature, you will hear a beeping sound indicating that the machine is ready
  • Place the stein in the element and close it by pulling the handle towards you
  • Press the green, round button to begin the pressing cycle (temperatures may drop which is normal)
  • Once the press temperature is reached, the timer will begin counting down
  • When the timer reaches 0, take out the stein from the press and remove the transfer paper immediately
  • Allow the stein to cool completely before use


4-in-1 Mug Press

Press Temperature: 360°F
Time: 180 - 240 Seconds
Pressure: Medium/Firm

  • Attach sublimation transfer paper with image printed in reverse to the stein with thermal tape
  • Place stein in press at the press temperature, and close the element around it
  • Press for the specified time above needed using specified pressure
  • If the image begins to look blurry, or burnt brown by over-pressing, decrease time by 15 - 30 seconds
  • Once done, remove the stein from the press and remove the transfer paper immediately
  • Allow the stein to cool completely before use


Oven Settings

Press Temperature: 400°F
Time: 15 Minutes
(test in your oven for accurate time)

  • Attach reversed printed image to stein with thermal tape
  • Wrap silicone wrap around stein surface and clasp at handle
  • Place in oven preheated to 400°F for approximately 15 minutes (test to determine best timing!)
  • Afterwards, remove wrap and transfer immediately
  • Allow the stein to cool completely before use

More Information
Manufacturer Coastal
Color White
Substrate Material Ceramic
Finish Gloss
Print Applications Dye-Sublimation