18oz Stainless Steel Sublimation Water Bottle with Flip Top Lid

Note: Be sure to remove the cap before pressing!

4-in-1 Mug Press - 10oz element

Press Temperature: 320°F
Time: 150 - 180 Seconds
Pressure: Medium/Firm

• Attach sublimation transfer paper with image printed in reverse to the bottle with thermal tape
• Place bottle in press at the press temperature, and close the element around the bottle
• Press for the specified time above needed using specified pressure
• If the image begins to look blurry, or burnt brown by over-pressing, decrease time by 15 - 30 seconds
• Once done, remove the bottle from the press and remove the transfer paper immediately
• Allow the water bottle to cool completely before use

Mug Master Pro Mug Press

Idle Temperature: 275°F
Press Temperature: 330°F
Time: 15 Seconds
Pressure: Medium

(Use the water bottle element in the mug press for this item!)

• Tape the sublimation paper with image printed in reverse to the water bottle with thermal tape
• When the heat press reaches the idle temperature, you will hear a beeping sound indicating that the machine is ready
• Place the water bottle in the element and close it by pulling the handle towards you
• Press the green, round button to begin the pressing cycle (temperatures may drop which is normal)
• Once the press temperature is reached, the timer will begin counting down
• When the timer reaches 0, take out the water bottle from the press and remove the transfer paper immediately
• Allow the water bottle to cool completely before use

Oven Settings

Press Temperature: 400°F
Time: 6 - 10 Minutes
(test in your oven for accurate time)

• Attach reversed printed image to water bottle with thermal tape
• Wrap silicone wrap around water bottle surface and clasp at handle
• Place in oven preheated to 400°F for approximately 6 - 10 minutes (test to determine best timing!)
• Afterwards, remove wrap and transfer immediately
• Allow the water bottle to cool completely before use