White Ceramic Oversized Sublimation Latte Mug - 17oz. (24/case) - OVERSTOCK

Note: Use the Latte Mug Element in the Mug Master Pro for this item!

Mug Master Pro Mug Press

Idle Temperature: 280°F
Press Temperature: 365°F
Time: 60 Seconds
Pressure: Medium

• Attach sublimation transfer paper with image printed in reverse to the mug with thermal tape
• Place mug in heat press on its side at the idle temperature, and close the element with medium pressure around the side
• Press the green, round button to begin the pressing cycle
• Once done, remove the mug from the press and remove the transfer paper immediately
• Allow the mug to cool completely before use

4-in-1 Mug Press

Press Temperature: 360°F
Time: 180 - 240 Seconds
Pressure: Medium/Firm

• Attach sublimation transfer paper with image printed in reverse to the mug with thermal tape
• Place mug in press at the press temperature, and close the element around the mug
• Press for the specified time above needed using specified pressure
• If the image begins to look blurry, or burnt brown by over-pressing, decrease time by 15 - 30 seconds
• Once done, remove the mug from the press and remove the transfer paper immediately
• Allow the mug to cool completely before use

Oven Settings

Press Temperature: 400°F
Time: 12 - 15 Minutes
(test in your oven for accurate time)

• Attach reversed printed image to mug with thermal tape
• Wrap silicone wrap around mug surface and clasp at handle
• Place in oven preheated to 400°F for approximately 12 - 15 minutes (test to determine best timing!)
• Afterwards, remove wrap and transfer immediately
• Allow the mug to cool completely before use